You can also specify a preset location to go to for a particular half hour slot, so 

for example you can have the camera on preset #2 from 9am to 5pm, then 

preset #3 from 5pm to midnight. 

Note that whenever patrolling is finished, either by schedule or by clicking the 

Patrol button, the camera returns to preset #1. 

Advanced Tab 

This lets you set up TCP Port Activated Motion Detection. This is used by some Axis 

devices such as the 241Q Video Server. 

In this scheme, motion detection is performed by the device rather than by 

Netcam Watcher. The device sends a TCP message to a specific port when 

motion starts and stops. Netcam Watcher can start and stop recording on receipt 

of these messages. 

Some points to note when using this feature: 

Each camera must use a seperate TCP port, and this must match the 

server port defined in the device. 

The messages set up in the device must match the messages in this 

dialog. Suggest you use messages like CAM1 ON...CAM1 OFF, etc 

When Use TCP Motion Detection is checked, this is activated when the 

camera is in motion detection mode. In this case, no current image is 

shown, but the Netcam Watcher waits for a TCP control message to start 

and stop recording. 

When the camera is in Monitor or Record All Frames mode it operates 

normally 

It is advisable to use this feature in conjunction with the Record for XX 

seconds after motion stops (on the Recording and Saving tab). This 

prevents dropped frames when the motion starts and stops rapidly. 

Please contact support if you need help getting this feature to work. 

14